Monday, October 21, 2019

Ethene essays

Ethene essays Distillation is the first step in the processing of crude oil and it takes place in a tall steel tower called a fractionation column. The inside of the column is divided at intervals by horizontal trays. The column is kept very hot at the bottom (the column is insulated) but as different hydrocarbons boil at different temperatures, the temperature gradually reduces towards the top, so that each tray is a little cooler than the one below. The crude needs to be heated up before entering the fractionation column and this is done at first in a series of heat exchangers where heat is taken from other process streams which require cooling before being sent to rundown. Heat is also exchanged against condensing streams from the main column. Typically, the crude will be heated up in this way upto a temperature of 200 - 280 0C, before entering a furnace. As the raw crude oil arriving contains quite a bit of water and salt, it is normally sent for salt removing first, in a piece of equipment called a desalter. Upstream the desalter, the crude is mixed with a water stream, typically about 4 - 6% on feed. Intense mixing takes place over a mixing valve and (optionally) as static mixer. The desalter, a large liquid full vessel, uses an electric field to separate the crude from the water droplets. It operates best at 120 - 150 0C, hence it is conveniently placed somewhere in the middle of the preheat train. When heavy oil fractions are passed in gas phase through a bed of powdered catalyst at a suitable velocity (0.1-0.7m/s), the catalyst and the gas form a system that behaves like liquid, i.e. it can flow from one vessel to another under the influence of a hydrostatic pressure. If the gas velocity is too low, the powder does not fluidise and it behaves like a solid. If velocity is too high, the powder will just be carried away with the gas. When the catalyst is properly fluidised, it can be continously transported from a reactor vessel, w...

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.